Chapter 15 VLAN Screens
Management Switch Card User’s Guide
596
Figure 403 VLAN Port Setting
The following table describes the labels in this screen.
15.8 VLAN Port Setting Slot Screen
Click VLAN > Port Setting and then click the ID of an active DSL line card. Use this screen to view
the VLAN settings on the DSL line card’s ports.
Table 322 VLAN Port Setting
LABEL DESCRIPTION
ID This is the slot number of a line card. Click the index number of an active line card to display
which of the line card’s ports belong to which VLANs.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on
page 1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was started.
Firmware This field displays the current firmware version installed on the line card.
To Next Page
Loading...
