Chapter 34 sys Commands
Management Switch Card User’s Guide
1042
The following example creates a client set for IPv6 address 2001:db8:1a2b:15:0:0:1a2f:0 with a
prefix length of 32 bits to use HTTPS to manage the system. Then it turns on the secured client set
and displays the settings.
34.3.9 sys time show Command
Syntax:
sys time show
This command displays the system’s current time. An example is shown next.
34.3.10 sys time set Command
Syntax:
sys time set <hh> [<mm> [<ss>]]
This command sets the system’s time. An example is shown next.
ras> sys client6 set 1 2001:db8:1a2b:15:0:0:1a2f:0 32 https
ras> sys client6 enable 1
ras> sys client6 show
secured client6:
idx enable ip6addr Mask telnet ftp web icmp ssh snmp https
--- ------ -------------------------------- ----- ------ --- --- ---- --- ---- ---
--
1 yes 2001:db8:1a2b:15::1a2f:0 32 - - - - - - V
2 no :: 0 - - - - - - -
3 no :: 0 - - - - - - -
4 no :: 0 - - - - - - -
5 no :: 0 - - - - - - -
6 no :: 0 - - - - - - -
7 no :: 0 - - - - - - -
8 no :: 0 - - - - - - -
9 no :: 0 - - - - - - -
10 no :: 0 - - - - - - -
11 no :: 0 - - - - - - -
12 no :: 0 - - - - - - -
13 no :: 0 - - - - - - -
14 no :: 0 - - - - - - -
15 no :: 0 - - - - - - -
16 no :: 0 - - - - - - -
ras> sys time show
current time is 17:57:01
ras>
ras> sys time set 10 01 45
To Next Page
Loading...
