Chapter 34 sys Commands
Management Switch Card User’s Guide
1038
34.3 sys Commands
Use these commands for system management and maintenance.
34.3.1 sys version Command
Syntax:
sys version
timeout <0~360>
Specify for how many minutes an administrator’s
configuration session can remain idle before the
system automatically logs the administrator out.
14
time set <hh> [<mm> [<ss>]]
Sets the system time. 8
show
Displays the current system time. 1
timeserver set none
Clears the time server settings. 8
daytime <ip-
address> [sync]
or
time|ntp <ip-
address> <utc[<+|-
>0100~1200]>
[sync]
Sets the time service protocol and IP address of a
time server.
sync: Gets the time and date.
8
show
Displays the time server settings. 1
sync
Gets the time and date from a predefined time
server.
8
user delete <name>
Removes a user account. 14
disable <name>
Stops a user from logging in. 14
enable <name>
Allows a user to log in. 14
online
Displays information about online users that are
logged into the switch. * denotes your session.
1
set <username>
<password>
<privilege>
Sets a user account and its level of access
privileges (1 ~ 14).
14
show
Displays authentication settings and user
accounts.
1
version
Displays the system’s general information such as
the model name and firmware version.
1
Table 387 sys Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
