ZyXEL Communications MSC1000G - SHDSL Port Setup Advanced Features

Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
253
9.10.2 SHDSL Port Setup Advanced Features
Click Port > SHDSL in the navigation panel to open the SHDSL Port Setup screen. Click the
Setup button to open the following screen. Use this screen to configure an SHDSL port’s detailed
settings.
Figure 160 SHDSL Port Setup: Advanced Features
The following table describes the fields in this screen.
SHDSL Profile Select a profile of SHDSL settings (such as the transfer rate, wire pair and signal to noise
ratio settings) to assign to this port. Use the SHDSL Profile screen to configure SHDSL
port profiles.
Note: All the SHDSL ports in an n-wire group must use the same profile.
Select Use the Select column to choose a DSL port from which you want to copy settings.
Table 112 SHDSL Port Setup: Line Card (continued)
LABEL DESCRIPTION
Table 113 SHDSL Port Setup: Advanced Features
LABEL DESCRIPTION
UP Click this to return to the previous screen.
General
Enable Select this check box to turn on this port.
SHDSL Profile Select a profile of SHDSL settings (such as the transfer rate, wire pair and signal to noise
ratio settings) to assign to this port. Use the SHDSL Profile screen to configure SHDSL
port profiles.
Span Alarm
Profile
Select an alarm profile to define the thresholds that trigger an alarm on the port when
exceeded. This alarm profile is for the whole span. This is the entire connection including
any SHDSL regenerators that might be located between the STU-C (SHDSL Termination
Unit - Central) and STU-R (SHDSL Termination Unit - Remote) end points. An SHDSL
regenerator amplifies the SHDSL signal in order to increase the connection distance.