Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
252
Figure 158 SHDSL Port Setup: Line Card
The following table describes the fields in this screen.
Table 112 SHDSL Port Setup: Line Card
LABEL DESCRIPTION
UP Click this to return to the previous screen.
Copy Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Select column to choose a DSL port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 159 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy the
settings. Click Select All to mark all of the port check boxes or click Select None to
clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring the screen again.
Port These are the numbers of the DSL ports on the line card.
Enable Select a check box in this column to turn on a port. Select the check box at the top of the
column to turn on all of the line card’s ports.
Customer
Information
Enter information to identify the subscriber connected to this DSL port. You can use up to
31 printable English keyboard characters (including spaces and hyphens).
To Next Page
Loading...
