ZyXEL Communications MSC1000G - Show Igmp Commands

Chapter 32 show Commands
Management Switch Card User’s Guide
948
32.3.12 show igmp Commands
Use the show igmp commands to display current IGMP settings and statistics. Use multicast
igmp enable
to enable IGMP first.
32.3.12.1 show igmp info Command
Syntax:
show igmp info
This command displays the current IGMP settings and the number of IGMP-related packets
received. The following figure shows an example.
32.3.12.2 show igmp group Command
Syntax:
show igmp group [<vid> <mcast_ip>]
where
This command displays the IGMP group information that is learned on the system or from the
specified VLAN.
32.3.12.3 show igmp port info Command
Syntax:
show igmp port info <slot-port>
ras> show igmp info
mode is igmpsnooping
number of queries = 0
number of reports = 0
number of leaves = 0
number of unknowns = 0
number of groups = 0
ras>
<mcast_ip> =
The multicast IP address.
ras> show igmp group
[multicast group info]
vid multicast group port slot timestamp
---- --------------- -------------------- ---------------- --------------
ras>