ZyXEL Communications MSC1000G - Sys User Set Command

Chapter 34 sys Commands
Management Switch Card User’s Guide
1057
34.6.1 sys user set Command
Syntax:
sys user set <username> <password> <privilege>
where
This command sets a local user administrator account and its level of access privileges.
The following example sets an administrator account with a user name of “bob”, password of
“smith”, and level 8 access privilege.
34.6.2 sys user delete Command
Syntax:
sys user delete <name>
where
This command removes a local user administrator account.
The following example removes the “fred” administrator account.
34.6.3 sys user enable Command
Syntax:
sys user enable <name>
where
This command turns on an administrator account.
The following example turns on the “bob” administrator account.
<username>
=
The user name for the account
<password>
=
The password for the account.
<privilege>
=
The user account’s level of access privileges (1 ~ 14).
ras> sys user set bob smith 8
<name>
=
The user name for the account.
ras> sys user delete fred
<name>
=
The user name for the account
ras> sys user enable bob