Chapter 30 profile Commands
Management Switch Card User’s Guide
885
30.14.1 profile profsvr show Command
Syntax:
profile profsvr show
This command displays the current profile server setting.
30.14.2 profile profsvr mode Command
Syntax:
profile profsvr mode client|server
This command sets the profile server operation mode.
30.14.3 profile profsvr clientlist set Command
Syntax:
profile profsvr clientlist set <ip-address> <type>
where
This command adds an entry to the profile server client list. When the IES is in server mode, use
this command to add entries to the list of client IES’s.
The following example sets a profile server client entry for an IES at IP address 1.2.3.4. If there are
any unused profiles on this client during the synchronization process, they will be left on the client.
30.14.4 profile profsvr clientlist delete Command
Syntax:
profile profsvr clientlist delete <ip-address>
ras> profile profsvr show
mode :server mode
no Client Ip type
---- --------------- ------
01 1.2.3.4 0
ras> profile profsvr mode server
<type>
=
A profile client IES may have unused profiles on it (profiles that are not mapped to any
ports).
Use
0 to leave these unused profiles on the client IES when synchronizing the profiles.
Use
1 to delete these unused profiles from the client IES when synchronizing the
profiles.
ras> profile profsvr clientlist set 1.2.3.4 0
To Next Page
Loading...
