ZyXEL Communications MSC1000G - Profile Acl Commands

Chapter 30 profile Commands
Management Switch Card User’s Guide
863
30.4 profile acl Commands
An ACL (Access Control List) profile allows the system to classify and perform actions on the
upstream traffic.
30.4.1 profile acl delete Command
Syntax:
profile acl delete <profile>
This command removes the specified ACL profile.
Note: You cannot remove the ACL profile(s) that is currently in use.
30.4.2 profile acl map Command
Syntax:
profile acl map <profile>
This command displays the DSL port(s) to which the specified ACL profile is applied.
The following example displays the port mapping table for the
example ACL profile.
30.4.3 profile acl set Command
Syntax:
profile acl set <name> <rule> <action>
<profile> default <sip-
profile>
Sets the default SIP profile for a dial plan
profile. The system uses the default SIP
profile instead when a dialed number does
not match any entries in the set dial plan
profile.
sip-profile: SIP profile name, up to 31
characters
8
dialplan
show
Displays the settings of all dial plan profiles
or of the specified profile.
1
map <name>
Displays which ports use the specified SIP
profile.
1
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P
ras> profile acl map example
port pvc
----- ------------------------------------------------------
3- 1 0-33