Management Switch Card User’s Guide 413
CHAPTER 12
Statistics Screens
This chapter describes the run-time statistics.
12.1 ARP Table
Address Resolution Protocol (ARP) is a protocol for mapping an Internet Protocol address (IP
address) to a physical machine address, also known as a Media Access Control or MAC address, on
the local area network.
An IP (version 4) address is 32 bits long. In an Ethernet LAN, MAC addresses are 48 bits long. The
ARP table maintains an association between each MAC address and its corresponding IP address.
12.1.1 How ARP Works
When an incoming packet destined for a host device on a local area network arrives at the switch,
the switch's ARP program looks in the ARP Table and, if it finds the address, sends it to the device.
If no entry is found for the IP address, ARP broadcasts the request to all the devices on the LAN.
The switch fills in its own MAC and IP address in the sender address fields, and puts the known IP
address of the target in the target IP address field. In addition, the switch puts all ones in the target
MAC field (FF.FF.FF.FF.FF.FF is the Ethernet broadcast address). The replying device (which is either
the IP address of the device being sought or the router that knows the way) replaces the broadcast
address with the target's MAC address, swaps the sender and target pairs, and unicasts the answer
directly back to the requesting machine. ARP updates the ARP Table for future reference and then
sends the packet to the MAC address that replied.
12.2 ARP Table Screen
Click Statistics > ARP Table in the navigation panel to open the following screen. This screen lists
the IP addresses that the system has mapped to MAC addresses.
To Next Page
Loading...
