Chapter 29 port Commands
Management Switch Card User’s Guide
835
This command sets a private VLAN setting on a specified DSL port. The following example sets up a
private VLAN with an IPv6 Ethernet type, an ID of 1 and a priority of 1 on traffic on port 5 on the
VDSL card in slot 4.
29.41.17 port vdsl rfiband Command
Syntax:
port vdsl rfiband <slot-port> <disable|ansi|etsi|custom>
where
Use this command to specify an RFI mode or disable this feature.
29.41.18 port vdsl rficustom Commands
Syntax:
port vdsl rficustom disable <index>
port vdsl rficustom enable <index>
port vdsl rficustom set <index> <start_freq> <stop_freq>
port vdsl rficustom show
where
Use these commands to configure or display the settings of a custom RFI entry.
An example is show below:
• Creates a custom RFI entry with the frequency between 3500 and 3800 kHz.
• Activate the settings.
<priority> =
The priority setting from 0~7
ras> port vdsl pvlan 4-5 86DD 1 1
<disable|ansi|etsi
|custom>
=
Enter ansi or etsi to use the pre-defined RFI band.
Enter
disable to deactivate this feature.
Enter
custom to use the RFI band settings configured using the
port vdsl rficustom command.
<index>
=
This is index number (1-8) of the custom RFI entry.
<start_freq>
=
This is the start of the frequency range in kHz (0~2147483647).
Note: <start_freq> cannot be bigger than <stop_freq>.
<stop_freq>
=
This is the end of the frequency range in kHz.
To Next Page
Loading...
