Management Switch Card User’s Guide 841
CHAPTER 30
profile Commands
This chapter shows you how to use the profile commands.
30.1 Profiles Overview
Profiles are groups of settings that you can assign to a port(s). This helps simplify and speed up port
configuration.
30.2 General profile Command Parameters
The following table describes commonly used profile command parameter notation.
Table 365 General profile Command Parameters
NOTATION DESCRIPTION
profile
The profile name, up to 31 characters.
Alarm profile settings
atuc: near end
atur: far end
lofs: The maximum time there is loss of framing (0~900 seconds).
loss: The maximum time there is a loss of signal (0~900 seconds).
lols: The maximum time there is a loss of link (0~900 seconds).
lprs: The maximum time there is a loss of power (0~900 seconds).
ess: The maximum time there is error (0~900 seconds).
ffr: The maximum time there are failed fast retrains (0~900 seconds).
sesl: The maximum time there are severe errors on the line (0~900 seconds).
uasl: The maximum time there the line is unavailable (0~900 seconds).
fru: The maximum transmission rate (0~2147483 Kbps).
iru: The maximum interleave rate (0~2147483 Kbps).
frd: The minimum transmission rate (0~2147483 Kbps).
ird: The minimum interleave rate (0~2147483 Kbps).
ift: Enables (1) or disables (0) the init failure trap.
To Next Page
Loading...
