Chapter 11 Profile Screens
Management Switch Card User’s Guide
372
11.18 IGMP Filter Profile Screen
You can use the IGMP filter profiles to control access to a service that uses a specific multicast
group (like a SIP server for example). Configure an IGMP filter profile that allows access to that
multicast group. Then assign the IGMP filter profile to ADSL ports that are allowed to use the
service.
Click Profile > IGMP Filter in the navigation panel to open the following screen. Use this screen to
configure IGMP filter profiles. Later you can apply the IGMP filter profiles to ADSL ports in the ADSL
Port Setup screens.
The DEFVAL IGMP filter profile is assigned to all ADSL ports by default. It allows a port to join all
multicast IP addresses (224.0.0.0~239.255.255.255). If you want to allow an ADSL subscriber
access to only specific IGMP multicast groups, use the IGMP Filter Profile screen to configure a
different profile and then assign it to the subscriber's ADSL port in the ADSL Port Setting screens.
Use the top part of the screen to add or edit IGMP filter profiles. The bottom of the screen lists the
configured IGMP filter profiles.
The bottom part of the screen lists the configured profiles.
Index This is the index number of the alarm profile.
Name This is the name of the alarm profile.
Modify Select a profile’s Select radio button and click Modify to edit the profile.
Delete Select a profile’s Select radio button and click Delete to remove the profile.
Table 175 Alarm SHDSL Profile (continued)
LABEL DESCRIPTION
To Next Page
Loading...
