Chapter 36 voip Commands
Management Switch Card User’s Guide
1069
36.2 voip arp Commands
Use these commands to control ARP (Address Resolution Protocol) on the VoIP line cards.
36.2.1 voip arp flush Command
Syntax:
voip arp flush <slot>
This command removes all ARP (Address Resolution Protocol) table entries stored in the specified
VoIP line card.
The following example deletes all ARP table entries from slot 4.
36.2.2 voip arp show Command
Syntax:
voip arp show <slot>
This command displays all ARP (Address Resolution Protocol) table entries stored in the specified
VoIP line card.
The following example displays all ARP table entries in slot 4.
36.3 voip countrycode Commands
Use these commands to set the country of operation, or the country with the same configuration as
the country of operation. The following lists the variables affected by the selected country code.
•AC impedance
• PCM companding law
•Cadence ring
•Flash time
• Pulse dial interval
ras> voip arp flush 4
ras> voip arp show 4
slot ip mac timer
---- --------------- ----------------- -----
3 192.168.2.2 00:0f:ea:7b:cb:a1 280
3 192.168.2.4 00:0f:ea:79:01:c3 30
3 192.168.2.11 00:08:02:da:6b:97 270
3 192.168.2.20 00:0f:ea:79:01:d3 270
3 192.168.2.52 00:05:5d:96:ea:78 40
3 192.168.2.136 00:13:49:24:b0:78 300
3 192.168.2.159 00:13:49:24:b0:77 300
To Next Page
Loading...
