Chapter 24 ima Commands
Management Switch Card User’s Guide
717
The following example shows the settings of IMA group 2 on slot 2.
24.4 ima mgtpvc Commands
Syntax:
ima mgtpvc set <slot-group-vpi/vci> <profile> <llc|vcmux> <pvid> <priority>
This command sets a bridged management PVC which provides an in-band management channel
between the MSC line card and a remote IES through an IMA connection.
The following example shows how to map management frames with a PVC on IMA group 2 of slot 2
using the following settings:
• Management frames: tagged with VLAN ID 100 and priority 7
• The name of an ATM profile applied to this PVC: DEFVAL
• PVC: 0/33 and using the llc encapsulation method
Syntax:
ima mgtpvc set <slot-group-vpi/vci> <profile> <llc|vcmux> <ip-address> <gateway-ip>
<pvid> <priority>
This command sets a routed management PVC (see Section 10.7 on page 325).
In the following example (same as Figure 214 on page 325), the IES (IMA-1) and the management
computer (M) are located in the central office site (CO). The inband management IP addresses of
IMA-1 is 192.168.1.1 and M’s IP address is 192.168.1.3. IMA-2 is the remote IMA device which
uses 192.168.1.2 for its inband manage IP address in the remote site (RT).
ras> ima group show 2-2
slot : 2
group : 2
state : enable
frame size : 128
frame sync alpha : 2
frame sync beta : 5
frame sync gamma : 5
clock mode : ctc loop
group symmetry : symop
max differential delay : 100
minimum link number : 2
link id in group : 1,2,6
ras> ima mgtpvc set 2-2-0/33 DEFVAL llc 100 7
To Next Page
Loading...
