Chapter 3 The Web Configurator
Management Switch Card User’s Guide
76
3.6.1 Card Status Details
To view detailed card status information, click an index number of an active card in the System
Info screen.
Figure 23 System Info: Slot
The following table describes the labels in this screen.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on
page 1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was
started.
Firmware This field displays the current firmware version installed on the line card.
Over Heat This field indicates whether the temperate of the line card is too high.
Voltage Failure This field indicates whether the voltage on the line card is out of the tolerance range.
Monitor Error This field indicates if no line card status information can be obtained.
Linecard Down This field indicates whether the line card has failed.
Linecard Out This field indicates whether the line card is removed from its slot.
Table 5 System Info (Home) (continued)
LABEL DESCRIPTION
Table 6 System Info: Slot
LABEL DESCRIPTION
Hardware Version This is the version of the physical device hardware.
Hardware Serial
Number
This is the individual identification number assigned to the device at the factory.
To Next Page
Loading...
