Chapter 26 ip6 Commands
Management Switch Card User’s Guide
729
The following example has the system send 4 pings to IP address 2001:db8:1a2b:15::1a2f:1.
26.2.4 ip6 show Command
Syntax:
ras> ip6 show
Use the command to display the current management IP settings. An example is shown next.
26.2.5 ip6 set Command
Syntax:
ras> ip6 set inband <ip-address>[/<prefix>] [<inband-vid> <gateway-ip>]
or
outband <ip-address>[/<prefix>] [<gateway-ip>]
ras> ip6 set inband 2001::10/64
ras> ip6 ping 2001::8
pinging 2001::8 with 32 bytes of data:
sent rcvd rate rtt avg mdev max min reply from
1 1 100 10 10 0 10 10 2001::8
2 2 100 0 9 3 10 0 2001::8
3 3 100 0 8 5 10 0 2001::8
ras> ip6 show
In-band IPv6 Link-local Address = fe80::213:49ff:fec9:8b5
Out-of-band IPv6 Link-local Address = fe80::213:49ff:fec9:8b3
IPv6 Default management: inband (swif0)
IPv6 Default gateway: [::]
Inband Management
IP Address[::]
Default Netmask[0]
Outband Management
IP Address[::]
Default Netmask[0]
Interface: Inband global address
Addresses PLen
Scope State Valid Preferred
----------------------------------------------------------------------
Interface: Outband global address
Addresses PLen
Scope State Valid Preferred
----------------------------------------------------------------------
To Next Page
Loading...
