Chapter 26 ip6 Commands
Management Switch Card User’s Guide
730
where
This command sets the system’s IPv6 addresses and in-band management VLAN (CPU). You can
only manage the system through ports that are members of the management VLAN.
Note: By default, you can access the management VLAN from all of the in-band ports
since they are all in the management VLAN. If you need more security, see Section
25.2.9.1 on page 725 for an example.
inband =
Sets the in-band management IP address.
outband =
Sets the out-of-band management IP address (for the MGMT port).
[<inband-
vid>]
=
Sets the VLAN ID (Identifier) of the management (CPU) VLAN. You must
connect to the system through a port that is a member of the management
(CPU) VLAN in order to perform in-band management.
<gateway-
ip>
=
The system’s default gateway IPv6 address.
To Next Page
Loading...
