ZyXEL Communications MSC1000G - Show Ip6 Route Command

Chapter 32 show Commands
Management Switch Card User’s Guide
956
An example is shown next. See Section 12.16.2 on page 478 for more details.
32.3.19 show ip6 route Command
Syntax:
show ip6 route
This command displays the IPv6 routing table. An example is shown next. See Section 12.16.4 on
page 479 for more details.
32.3.20 show ipbpvc arpproxy Command
Syntax:
show ipbpvc arpproxy all
show ipbpvc arpproxy domain <domain-name>
show ipbpvc arpproxy edgerouter [<ip> <vid>]
show ipbpvc arpproxy interface [<ip/mask> <vid>]
ras> show ip6 prefix
Interface: In-band
Prefix vltime pltime expire onlink autonomous
-------------------------- --------- --------- --------- ------ ----------
fe80::/64 infinity infinity Never TRUE TRUE
Interface: Out-of-band
Prefix vltime pltime expire onlink autonomous
-------------------------- --------- --------- --------- ------ ----------
fe80::/64 infinity infinity Never TRUE TRUE
ras> show ip6 route
Interface: In-band
Address Gateway/Interface Name
------------------------------------- -------------------------------------
fe80::/64 In-band
fe80::213:49ff:fec9:8b5 fe80::213:49ff:fec9:8b5
ff01::/32 In-band
ff02::/32 In-band
Interface: Out-of-band
Address Gateway/Interface Name
------------------------------------- -------------------------------------
fe80::/64 Out-of-band
fe80::213:49ff:fec9:8b3 fe80::213:49ff:fec9:8b3
ff01::/32 Out-of-band
ff02::/32 Out-of-band