Chapter 34 sys Commands
Management Switch Card User’s Guide
1051
The following example shows the administrator at IP address 123.23.19.11 ordering a reboot to
occur after 1200 seconds, displaying the reboot schedule and then canceling the reboot.
34.3.28 sys server port Command
Syntax:
sys server port telnet|ftp|web|snmp|
ssh|https <port>
This command changes the port for a service on the system.
The following example sets the system to use port 24 for Telnet sessions.
34.3.29 sys server disable Command
Syntax:
sys server enable telnet|ftp|web|snmp|ssh|https
This command turns off access for a service on the system.
The following example sets the system to block Telnet sessions.
34.3.30 sys server enable Command
Syntax:
sys server enable telnet|ftp|web|snmp|ssh|https
This command turns on access for a service on the system.
The following example sets the system to allow Telnet sessions.
ras> sys reboot 1200
telnet-1(123.23.19.11) has initiated reboot, system reboot in 1200 seconds!
ras> sys reboot show
issued by remaining time issue time
-------------------------- -------------- ------------------------
telnet-1(123.23.19.11) 1196 Wed Jun 8 15:26:54 2005
ras> sys reboot cancel
telnet-1(123.23.19.11) has cancelled system reboot!
ras> sys server port telnet 24
ras> sys server disable telnet
ras> sys server enable telnet
To Next Page
Loading...
