Chapter 30 profile Commands
Management Switch Card User’s Guide
902
• G.711 voice package interval: 20
• G.723 voice package interval: 30
• G.726 voice package interval: 20
• G.729 voice package interval: 20
The following example shows a command configuring a DSP profile named “digsig4” with the
following settings:
• Codec: G.726 (40 bits), G.726 (32 bits), G.726 (16 bits).
• Min-delay: 30 ms
• Max-delay: 90 ms
• Echo tail: 32 ms
30.19.4 profile voip dsp show Command
Syntax:
profile voip dsp show [<profile>]
This command displays the settings of the specified DSP profile, or displays the names of all DSP
profiles if none is specified. An example is shown next.
30.20 profile voip h248 Commands
Use these commands to set up and manage h248 profiles. h248 profiles map to ports on the VoIP
line cards, and contain the media gateway details.
ras> profile voip dsp set digsig4 codec g726-40,g726-32,g726-16 playbuffer
30 90 echotail 32
ras> profile voip dsp show
dsp profile(s)
-------------------------
1. DEFVAL
2. digsig4
ras> profile voip dsp show digsig4
dsp profile : digsig4
codec : g726-40 g726-32 g726-16
playbuff min-delay : 30
playbuff max-delay : 90
echotail : 32
echocancel : on
vad : off
g711vpi : 20
g723vpi : 30
g726vpi : 20
g729vpi : 20
To Next Page
Loading...
