ZyXEL Communications MSC1000G - Acl Arpinspection Disable Command

Chapter 19 acl Commands
Management Switch Card User’s Guide
656
19.3.1 acl arpinspection disable Command
Syntax:
acl arpinspection disable <slot-port>
This command turns off ARP inspection on the specified subscriber port(s). This helps conserve the
system’s resources.
19.3.2 acl arpinspection enable Command
Syntax:
acl arpinspection enable <slot-port>
This command turns on ARP inspection on the specified subscriber port(s).
19.3.3 acl arpinspection show Command
Syntax:
acl arpinspection show <slot-port>
This command displays ARP inspection settings on the specified subscriber port(s).
19.4 acl dhcprelay82 Commands
Use these commands to configure the DHCP relay feature.
19.4.1 acl dhcprelay82 clearinfo Command
Syntax:
acl dhcprelay82 clearinfo <vid>
This command deletes the relay agent information settings.
19.4.2 acl dhcprelay82 enable Command
Syntax:
acl dhcprelay82 enable <vid> <mode>
where
<vid> =
ID of the VLAN to which this setting applies.