Chapter 8 Multicast Screens
Management Switch Card User’s Guide
202
Figure 123 MVLAN Group Setup
The following table describes the labels in this screen.
8.10 Misc Screen
Click Multicast > Misc in the navigation panel to display the screen shown next. Use this screen to
configure how the MSC handles IPv4 and IPv6 multicast unknown groups, IPv4 reserved multicast
groups, and IPv6 multicast packets.
Table 85 MVLAN Group Setup
LABEL DESCRIPTION
VID This is the ID number of the MVLAN.
Index Select the multicast group number (1 -16).
Start IP Enter a multicast IP address as the beginning of the multicast IP address range.
End IP Enter a multicast IP address as the finish of the multicast IP address range.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to start configuring this section of the screen again.
Index This is the multicast group number (1 -16).
Start IP This is the beginning of the multicast IP address range.
End IP This is the finish of the multicast IP address range.
Select Select the check box in the Select column for an entry and click Delete to remove the entry.
Select All Click this to select all entries in the table.
Delete Select the radio button in the Select column for an entry. Click Delete to remove the entry.
Cancel Click Cancel to start configuring this section of the screen again.
To Next Page
Loading...
