ZyXEL Communications MSC1000G - Port Ipbpvc Arpproxy Flush Command

Chapter 29 port Commands
Management Switch Card User’s Guide
796
29.16.2 port ipbpvc arpproxy flush Command
Syntax:
port ipbpvc arpproxy flush <all | edgerouter [<ip-address> <vid>] | interface [<ip/
mask> <vid>]>
where
This command clears the specified entries in the Address Resolution Protocol table(s).
29.16.3 port ipbpvc arpproxy show Command
Syntax:
port ipbpvc arpproxy show
This command displays how long the device stores the IP addresses of IP bridge devices in the
Address Resolution Protocol table.
The following is an example.
29.17 IP Bridge PVC Commands
Use the port ipbpvc delete, set (see Section 29.22.4 on page 805) and show (see Section
29.22.5 on page 806) commands to set up and maintain PVCs for subscribers in an IP bridge.
IP bridge PVCs are similar to regular PVCs and are endpoints of the IP bridge. In addition, IP bridge
PVCs are one of two types, IP over Ethernet or IP over ATM, depending on the underlying network.
The PVID is used to identify the domain the PVC is in, so the PVID must be in a domain.
29.18 port ipbpvc delete Command
Syntax:
port ipbpvc delete <slot-port-vpi/vci>
all =
All ARP table entries.
<ip-address>=
IP address, in dotted decimal notation.
<mask>=
Number of bits <1..32> in the subnet mask.
<vid>=
The ID (<1..4094>) of the VLAN.
ras> port ipbpvc arpproxy show
age=300 (sec)