Chapter 36 voip Commands
Management Switch Card User’s Guide
1092
36.16 voip sip localcall Command
Use these commands to manage the local call feature used by the VoIP SIP line cards. Local call lets you
configure which local subscribers are called instead of public emergency (or other) numbers in the event that the
link to the VoIP provider is not available.
36.16.1 voip sip localcall show Command
Syntax:
voip sip localcall show [<name>]
This command displays contents of the specified local call table. An example is shown to display the local call
table named “localcall_table”.
36.16.2 voip sip localcall time Command
Syntax:
voip sip localcall time <enter-time> <exit-time>
where
This command sets the time for loss/recovery connection with SIP proxy server to enter local call service.
callwaitonhold =
Enter the key the user presses to place a current call on hold and accept a
waiting call (one character only).
callwaitreject =
Enter the key the user presses to reject a waiting call (one character only).
clir =
Enter the sequence of keys the user presses to restrict his/her phone
number by not sending caller ID information (1~7 characters).
dndoff =
Enter the sequence of keys the user presses to turn off Do Not Disturb (1~7
characters).
dndon =
Enter the sequence of keys the user presses to turn on Do Not Disturb (1~7
characters).
callin =
Enter the sequence of keys the user presses to turn on the Call In feature.
When the Call In feature is active, the system limits call ringing time to ten
seconds.
repeat dialing =
Enter the sequence of keys the user presses to turn on the repeat dialing
feature.
ras> voip sip localcall show localcall_table
localcall name : localcall_table
index tel-number
----- ----------------
1 33334444
2
<enter-
time>
=
The time is for loss connection with SIP proxy server to enter local call service
(1~60 minutes). The default is 1.
<exit-
time>
=
The time is for recovery connection with SIP proxy server to exit local call service
(1~60 minutes). The default is 1.
To Next Page
Loading...
