ZyXEL Communications MSC1000G - Page 1037

Chapter 34 sys Commands
Management Switch Card User’s Guide
1037
server enable telnet|ssh|ftp|web
|icmp|snmp|https
Turns on service access to the switch. 8
disable telnet|ssh|ftp|web
|icmp|snmp|https
Turns off service access to the switch. 8
port telnet|ftp|web|snm
p|ssh|https <port>
Sets a port for a service. 8
show
Displays service access control settings. 1
snmp getcommunity <community>
Sets the SNMP GetRequest community. 8
setcommunity <community>
Sets the SNMP SetRequest community. 8
show
Displays SNMP settings. 1
trapcommunit
y
<community>
Sets the SNMP Trap community. 8
trapdst <index>
<destination>
[<port>]
[v1|v2c|v3]
[<name>]
Sets the IP addresses and listening ports for up to
four SNMP trap server IP addresses and listening
ports. Set 0.0.0.0 to not send any SNMP traps.
name: username to be included in trap packets.
Only applicable for V3.
8
user <name>
noauth|auth|priv
md5|sha des|aes
Sets SNMPv3 user name and security settings.
noauth: disables user authentication and data
encryption.
auth: enables user authentication.
pri: enables user authentication and data
encryption.
md5|sha: authentication method.
des|aes: encryption method.
8
version v2c|v3|v3v2c
Sets the system to use the specified SNMP version
and access.
v2c: SNMPv2 read/write
v3: SNMPv3 read/write
v3v2c: SNMPv3 read/write and SNMPv2 read-
only.
8
syslog disable
Turns off syslog logging. 8
enable
Turns on syslog logging. 8
server <fac> <ip-address>
Sets the log facility (local1~local7) to log the
syslog messages to a specific file in the syslog
server. See your syslog program’s documentation
for details. Sets the syslog server IP address.
8
show
Displays the syslog settings. 1
session loginmsg
Enter a mode that lets you specify a note to
display when users attempt to log into the
system’s management interfaces.
14
show
Displays the session timeout setting and the login
message.
1
Table 387 sys Commands (continued)
COMMAND DESCRIPTION P