Chapter 34 sys Commands
Management Switch Card User’s Guide
1036
date set <yyyy> <mm> <dd>
Sets the system date. 8
show
Displays the current system date. 1
info chassis <chassis>
Sets the system chassis number (1~64). 8
contact <contact>
Sets contact person information. 8
frame <frame>
Sets the system frame number. 8
hostname <hostname>
Sets the system name. 8
location <location>
Sets the geographic location of the system. 8
show
Displays general system and system information. 1
monitor set <slot>
<volt|temp|fan|cpu
|mem|pbuf> <index>
<high-limit> <low-
limit>
Sets hardware monitor alarm thresholds.
volt: Voltage
index: 1~5 (the number of voltage sensors varies
by card)
temp: temperature
index: 1~3
fan: for system FAN,
index: 1~6 (the number of fans varies by
chassis)
cpu: CPU
index: 1
mem: Memory
index: 1
pbuf: Packet buffer for transmission and receiving.
index: 1
8
show <slot>
Displays the hardware monitor threshold settings
of a slot.
1
multilogin disable
Turns off multiple concurrent logins. 8
enable
Turns on multiple concurrent logins. 8
privilege set [all] <privilege>
<command>
Sets the privilege level required to execute all
commands or a specific command. See Section
37.6 on page 1101 for the command strings to
permit on the TACACS+ server to allow various
FTP actions.
14
show <command>
Displays the privilege level required to execute all
commands or a specific command.
1
show
Displays the multiple login setting. 1
reboot
Restarts the system. 14
[show|sec|ca
ncel]
show: Displays the reboot schedule.
sec: Sets the number of seconds (1~2147483647)
before the system reboots. If there is no time
specified, the system reboots immediately.
cancel: Aborts the scheduled system rebooting.
8
Table 387 sys Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
