Chapter 29 port Commands
Management Switch Card User’s Guide
774
set <slot-port>
<svid> <spriority>
<cvid> <cpriority>
Sets the double tagging settings on a port.
svid: service provider VLAN ID, 0~4094
spri: service provider VLAN priority, 0~7
cvid: customer VLAN ID, 0~4094
cpri: customer VLAN priority, 0~7
8
frametype <slot-port> <all|tag>
Sets the acceptable frame type on the port(s). 8
paepvc delete <slot-port-
vpi/vci>
Removes a PAE PVC (PPPoA-to-PPPoE PVC). 8
set <slot-port-vpi/
vci> llc|vcmux <pvid>
<priority> [acname
<acname>] [srvcname
<srvcname>]
[hellotime
<hellotime>]
Configures a PVC for PAE translation.
pvid: private VLAN ID, 1~4094
priority: IEEE 802.1p priority for traffic that
belongs to this VLAN, 0~7
acname: The host name of the access concentrator,
length <=31.
srvcname: A descriptive name for the service that
uses this PVC.
hellotime: The timeout (0~600 seconds) for the
PPPoE session.
8
show <slot>|<slot-
port>|<slot-port-
vpi/vci>
Displays the PAEPVC settings for a slot, a port or a
PVC.
8
priority <slot-port>
<priority>
Sets the port(s)’ VLAN priority (0~7). 0 is the
lowest priority level and 7 is the highest.
8
pvc delete <slot-port-
vpi/vci>
Removes a PVC. 8
set <slot-port-vpi/
vci> llc|vcmux <pvid>
<priority>
Configures a PVC for subscribers using ATM-based
ADSL CPEs.
pvid: private VLAN ID, 1~4094
priority: IEEE 802.1p priority for traffic that
belongs to this VLAN, 0~7
8
show <slot>|<slot-
port>|<slot-port-
vpi/vci> [detail]
Displays the PVC settings for a slot, a port or a
PVC. If detail is specified, you can also see the
VLAN information.
1
pvid <slot-port> <vid>
Sets the port VID on the port(s). 8
pvlan delete <slot-port>
<etype>
Deletes a protocol VLAN setting on a specified port. 8
set <slot-port>
<etype> <vid>
<priority>
Sets the protocol VLAN settings on a specified port. 8
qratelimit <slot-port> <profile>
Assigns a profile of per-queue rate limiting
parameters to the specified port.
8
Table 364 port Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
