ZyXEL Communications MSC1000G - Page 756

Chapter 29 port Commands
Management Switch Card User’s Guide
756
Table 364 port Commands
COMMAND DESCRIPTION P
port adsl alarmprof <slot-port>
<alarmprofile>
Applies an ADSL alarm profile to the subscriber
port.
8
annexl disable <slot-port>
Turns off the Annex L reach extended feature. 8
enable <slot-port>
[narrow]
Turns on the Annex L reach extended feature. If
‘narrow’ is not specified then Annex L mode will be
enabled in ‘wide’ PSD mode.
8
annexm disable <slot-port>
Turns off the Annex M double upstream feature. 8
enable <slot-port>
Turns on the Annex M double upstream feature
(upstream tones from 6 to 63).
8
annexi disable <slot-port>
Turns off the Annex I all digital mode feature. 8
enable <slot-port>
Turns on the Annex I all digital mode feature. 8
dscarrier0 <slot-port> <m1> <m2>
<m3> <m4> <m5> <m6>
<m7>
Disables downstream carrier tones from 33 to 255.
m1~m7: carrier tones, 0~ffffffff,
'1' disables the corresponding tone.
8
dscarrier1 <slot-port> <m1> <m2>
<m3> <m4> <m5> <m6>
<m7>
Disables downstream carrier tones from 256 to
511.
m1~m7: carrier tones, 0~ffffffff,
'1' disables the corresponding tone.
8
inpmin <slot-port> <us_inp>
<ds_inp>
Sets the upstream and downstream Impulse Noise
Protection minimum setting
us_inp: The minimum upstream impulse noise
protection setting (0~6).
ds_inp: The minimum downstream impulse noise
protection setting (0~6).
8
optionmask <slot-port>
<option_mask>
Sets option mask attributes on a line card port. 8
pmm disable <slot-port>
Turns off the power management mode. 8
enable <slot-port>
[L2|L3]
Turns on the power management mode.
L2: power management mode L2
L3: power management mode L2 and L3
8