Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
280
Figure 178 ADSL Pair Bonding Example
The next figure shows a large organization using port bonding on multiple DSL lines between an
IES-708-22A (A) and an SHDSL line card in the IES (B) to connect to the Internet.
Figure 179 SHDSL Pair Bonding Example
The following shows how to use the G.bond Setup screen to configure port bonding settings.
Before you begin you need to have an active DSL line card that supports port bonding installed and
connected to multiple DSL lines.
1 Click Port > G.bond to open the G.bond Setup screen.
2 Select the ID number of an active DSL line card that supports port bonding in the Slot field.
3 You can create a new group of DSL lines on which to use port bonding, or edit an existing group’s
details.
• To create a new group, click New.
• To edit an existing group, select a group from the Group drop down field and click Load.
4 Type a descriptive name in the Name field to identify a group of DSL lines connecting the ISP with
the end-user, for example “Group1”.
5 Click the link next to Member Port to configure the ports for this set of DSL lines. A popup list of
ports appears.
To Next Page
Loading...
