Chapter 9 Subscriber Port Setup Screens
Management Switch Card User’s Guide
282
Figure 180 Port > G.bond
The following table describes the labels in this screen.
Table 128 Port > G.bond
LABEL DESCRIPTION
Slot Select the number of a line card’s slot to apply G.bond settings on traffic through this card.
Group The group represents a bundle of DSL lines connecting the line card and CPE DSL device.
Select a group from the drop-down list. If no groups have been configured yet, click New to
set up a new group.
Load Click Load to display the group’s G.bond settings in the Name and Member Port fields.
Name Use this section of the screen to display, set or edit a descriptive name for a group of DSL
lines.
Select a group in the Group drop-down list to display the group name in the Name field.
Type a descriptive name for a group in this field or edit an existing name to set up a new
group.
To Next Page
Loading...
