ZyXEL Communications MSC1000G - Page 546

Chapter 13 Switch Screens
Management Switch Card User’s Guide
546
Figure 377 Switch CFM > LBR
The following table describes the labels in this screen.
Table 291 Switch CFM > LBR
LABEL DESCRIPTION
MSC1000G Enable or disable loopback testing on the MSC’s ports.
Apply Click Apply to save the changes in this section to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Slot
Port
Use the drop-down list boxes to select a DSL port on a line card for which you want to enable
or disable loopback testing.
Load Click Load to display the port’s current settings.
Enable Enable or disable loopback testing on the DSL port.
Apply Click Apply to save the changes in this section to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to reset the fields.
ID This is the slot number of a line card. Click the index number of an active line card to display
a screen that lists whether loopback testing is enabled or disabled for each of the line card’s
ports.