ZyXEL Communications MSC1000G - Page 684

Chapter 20 alarm Commands
Management Switch Card User’s Guide
684
edit <alarm>|all
<fac>
<target>[,<targ
et>]
Edits an alarm report entry. 8
xedit <alarm> <cond>
<severity>
<fac>
<target>[,<targ
et>]
<clearable>
Sets the severity level of an alarm(s) and
where the system is to send the alarm(s).
clearable: Options are clearable or
unclearable.
8
history port show
<slot>|<slot-
port>|<giga-
port>
Displays historic alarms on a slot, a subscriber
port or a gigabit Ethernet port.
giga-port: enetx where x is the port number.
1
clear <alarm>|all
<condition>|all
Removes historic alarm entries by alarm
category and alarm condition or by severity.
8
clear <severity>
show [<severity>|all]
[<alarm>|all]
[<condition>|all
] [<sdate>|all]
[<edate>|all]
[for|rev]
[detail]
Displays historic alarms by severity, alarm
category and alarm condition. You can also
display detailed alarms.
1
input name <index> <name>
Sets the names for external alarms.
index: 1~4. This is the index number for the
external alarm input.
name: Enter 1 to 31 characters for the name of
the connected external alarm system.
8
show
Displays the external alarm names. 1
port show <slot>
Displays port alarm severity level thresholds. 1
set all|mgmt|<giga-
port>|<slot-
port> <severity>
Sets the severity of alarms to record for
individual ports.
mgmt: This is the management port.
8
show [<severity>|all]
[<alarm>|all]
[<condition>|all
] [<sdate>|all]
[<edate>|all]
[for|rev]
[detail]
Displays current alarms by severity, alarm
category or alarm condition. You can also
display detailed alarms.
1
tablelist [<alarm>|all]
[<severity>|all]
[<fac>|all]
[<target>[,<targ
et>]]
[<condition>|all
]
Displays the supported alarm list and report
settings.
1
Table 349 alarm Commands (continued)
COMMAND DESCRIPTION P