ZyXEL Communications MSC1000G - Page 853

Chapter 30 profile Commands
Management Switch Card User’s Guide
853
set <profile> [eimfe <eim>]
[eimne <eim>] [ccpfe <ccp>]
[ccpne <ccp>] [iatofe
<iato>] [iatone <iato>]
[iatsfe <iats>] [iatsne
<iats>] [isdbne <isdb>]
Creates a VDSL2 Impulse Noise Monitoring
profile. The parameters ending with “fe”
mean “far end” while those ending with “ne”
mean “near end”.
eim: equivalent INP mode, 0~3.
ccp: cluster continuation parameter, 0~64.
iato: inter arrival time offset for the IAT
anomaly generation, 3~511.
iats: inter arrival time step for the IAT
anomaly generation, 0~7.
isdb: ISDD sensitivity, -128~127 in units of
0.1dB (upstream only).
8
show [<profile>]
Displays a VDSL2 Impulse Noise Monitoring
profile.
1
lineprofi
le
delete <profile>
Removes a VDSL2 line profile. 8
set <profile>
.......................
Creates a VDSL2 line profile. See Section
30.18.1 on page 894 for details on this
command.
8
show [<profile>]
Displays a VDSL2 line profile. 1
template delete <name>
Removes a VDSL2 template. 8
map <name>
Displays a VDSL2 template’s mapping. 1
set <name> <line-profile>
<chan-profile> <inm-
profile>
Creates a VDSL2 template. 8
show [<name>]
Displays a VDSL2 template. 1
voip dsp delete <name>
Removes a specified DSP configuration profile
(<=32 characters).
8
map <name>
Displays the subscribers that reference the
specified DSP profile.
1
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P