Chapter 30 profile Commands
Management Switch Card User’s Guide
859
callsvc
set
<profile> [keypattern
<pattern-table>]
[registration off|{on <re>}
[dialplan off|on {<cc>
<ndc> <dialplan-table>}]
[localhelp off|on {<tel-
number> <localhelp-table>
[<tel-number> <localhelp-
table>...]}]
[dnd on|off]
[dtmf
bypass|rfc2833|sipinfo|rfc2
833like|plaintext]
[callhold on|off]
[callwait on|off]
[clip on|off]
[clir on|off]
[calltransfer on|off]
[conference on|off]
[fax t38|g711]
[firstdigit <fdt>]
[interdigit <idt>]
[flash
invite|rfc2833|rfc2833like|
sipinfo1|sipinfo2|sipinfo3|
sipinfo4|{sipinfo5 [<rc>]}|
For the MSC1024GC.
Configures a new call service profile.
keypattern: Enter the VoIP key pattern to use.
pattern-table:The VoIP keypattern table
name (<=31 characters).
registration:
choose on and enter a time period (<re>) to have
the system use the registration timeout feature. If
the system does not receive a registration
confirmation message from the SIP server in the
time specified, it drops the connection. Select off
to not use the registration timeout feature.
dialplan: Turn the dial plan table feature on or
off.
dialplan-table: The dialing plan table name
(<=31 characters).
tel-number: The local help telephone number
(<= 15 characters, only digit characters are allowed
and before call is disconnected).
localhelp: Turn the local help table feature on or
off. Specify the name of the local help table you
want users to access when they call a specific
telephone number.
localhelp-table: The local help table name
(<=31 characters).
cc: Local country code. This defines the digits the
numbering plan inserts when a rule contains “\c”.
ndc: Local national destination code. This defines
the digits the numbering plan inserts when a rule
contains “\d”.
dnd: Turn Do not Disturb on or off.
dtmf bypass: Do not relay DTMF signals.
rfc2833: Sets the system to relay DTMF tones
according to RFC2833.
sipinfo: Sets the system to relay DTMF signals
via SIP INFO message.
rfc2833like: Sets the system to relay DTMF
signals via SIP INFO but carrying RFC2833
payload.
8
Table 366 profile Commands (continued)
COMMAND DESCRIPTION P
To Next Page
Loading...
