Chapter 30 profile Commands
Management Switch Card User’s Guide
907
This command creates and configures a SIP profile. The values of the default SIP profile “DEFVAL”
are as follows:
• SIP server domain name: 0.0.0.0
• SIP registrar server domain name: 0.0.0.0
• SIP proxy server domain name: 0.0.0.0
• SIP server port number: 5060
• SIP registrar server port number: 5060
• SIP proxy server port number: 5060
•URI type: SIP
• IEEE 802.1p tag: 7
• DSCP tag: 48
• Keep alive: off
•PRACK: off
• Resend percentage: 50 %
• Nonce count keep: off
• QoP quotes: on
• Refer-To Bracket: off
• Refer-To Dot: hex
• RTP port range start: 50000
• RTP port range end: 60000
uritype tel =
The profile uses TEL URI.
<pbit> =
The IEEE 802.1p priority tag for SIP and RTP packets (0 ~ 7).
<dscp> =
The DiffServ Code Point for SIP and RTP packets (0 ~ 63).
keepalive =
Turn SIP session keepalive off or on. When this is on, the SIP UA periodically
sends SIP session refresh requests.
<se> =
The minimum session expiration time in seconds (90 ~ 65535).
prack =
The PRovisional ACKnowledgement response sent in reply to a SIP INVITE
request. PRACK support can be activated (prack on) or deactivated (prack
off).
resend =
Set after what percent of the Session Expiration time the IES resends a
registration message.
noncecountkeep =
Set this to on to protect against replay attacks.
qopquote =
Set whether or not the IES adds quotation marks around the qop (quality-
of-protection) value.
refertobracket =
Set whether or not to use additional brackets for the Refer-To header.
refertodot =
Set the IES to use dotted decimal or hexadecimal format for the IP address
in the SIP Refer-To header’s Replaces value.
rtpport =
Set a range of RTP (Real time Transport Protocol) ports to use for voice data
transfer.
Starting port should be even, 4000~64000.
Ending port should be even, 5000~65000.
There should be at least 1000 between the starting port and the ending
port.
To Next Page
Loading...
