Chapter 30 profile Commands
Management Switch Card User’s Guide
909
where
This command creates and configures a SIP profile. The values of the default SIP profile “DEFVAL”
are as follows:
• SIP server domain name: 0.0.0.0
• SIP server port number: 5060
• SIP registrar server IP address: 0.0.0.0
• SIP registrar server port number: 5060
<sip-ip> =
The SIP server IP address.
<profile> =
Up to 31 characters to identify the profile.
<sip-dn> =
The SIP server domain name (maximum 63 characters).
<regsvr-ip> =
The SIP registrar server IP address.
<regsvr-dn> =
The SIP registrar server domain name (maximum 63 characters).
<proxysvr-ip> =
The SIP proxy server IP address.
<proxysvr-dn> =
The SIP proxy server domain name (maximum 63 characters).
<sip-port> =
The SIP server port number (1025 ~ 65535).
<regsvr-port> =
The registrar server port number (1025 ~ 65535).
<proxysvr-
port>
=
The SIP proxy server port number (1025 ~ 65535).
<pbit> =
The IEEE 802.1p priority tag for SIP and RTP packets (0 ~ 7).
<dscp> =
The DiffServ Code Point for SIP and RTP packets (0 ~ 63).
keepalive =
Turn SIP session keepalive off or on. When this is on, the SIP UA periodically
sends SIP session refresh requests.
<se> =
The minimum session expiration time in seconds (90 ~ 65535).
prack =
The PRovisional ACKnowledgement response sent in reply to a SIP INVITE
request. PRACK support can be activated (prack on) or deactivated (prack
off).
<switchtype> =
Set the switch type of the SIP server: DEFVAL|NSN|ALU.
NSN: Nokia Siemens
ALU: Alcatel Lucent
DEFVAL: This is also Nokia Siemens.
<regist-
expire>
=
Set the registration expiration time for the registered state, 120~65535
seconds.
<regist-retry> =
Set the registration retry time for the un-registered state, 120~900
seconds.
<prefix-add-
digits>
=
Set the prefix digits to add, up to 15 characters. Spaces are not allowed.
rtpport =
Set a range of RTP (Real time Transport Protocol) ports to use for voice data
transfer.
Starting port should be even, 4000~64000.
Ending port should be even, 5000~65000.
There should be at least 1000 between the starting port and the ending
port.
To Next Page
Loading...
