Chapter 30 profile Commands
Management Switch Card User’s Guide
918
This command creates and configures a SIP call service profile. The values of the default SIP call service profile
are as follows:
• Key pattern table: DEFVAL
<localhelp-
table>
=
The name of the local help table name, up to 31 characters.
dnd
=
Do not Disturb allowed/prohibited.
dtmf bypass
=
The system does not relay DTMF signals.
dtmf rfc2833 =
The system relays DTMF signals according to RFC 2833.
dtmf sipinfo =
The system to relay DTMF signals via SIP INFO message.
dtmf
rfc2833like
=
The system to relay DTMF signals via SIP INFO but carrying RFC2833 payload.
callhold
=
Call holding allowed/prohibited.
callwait
=
Call waiting allowed/prohibited.
clip =
Caller Line Identification Presentation allowed/prohibited.
clir
=
Caller Line Identification Restriction allowed/prohibited.
calltransfer
=
Call transferring allowed/prohibited.
conference
=
Turns support for conference calls allowed/prohibited.
fax g711 =
The system relays fax signals according to ITU-T G.711.
fax t38 =
The system relays fax signals according to ITU-T T-38.
firstdigit
=
Set the number of seconds a person has to dial the first digit after taking the phone off-
hook.
interdigit
=
Set the number of seconds a person has between dialing digits.
flash =
Select the method the system uses to process the flash signal from a user.
invite =
Relays flash by SIP INVITE signal.
rfc2833
=
Relays flash according to RFC 2833.
rfc2833like
=
Relays flash in SIP INFO packets, but carried as RFC 2833 payload.
sipinfo1
=
Relays flash in SIP INFO packets (a signal=16 message).
sipinfo2
=
Relays flash in SIP INFO packets (a signal=hf message).
sipinfo3
=
Relays flash in SIP INFO packets (a signal=hook-flash message).
sipinfo4
=
Relays flash in SIP INFO packets (a plain text “FLASH” message).
sipinfo5
=
Relays flash in SIP INFO packets (multiple SIP messages). The message content is
determined by the characters you enter for <rc>. A separate SIP INFO message is
sent for each character you enter.
sipinfo6
=
Relays flash in SIP INFO packets (where the content of the message is determined by
the text you enter for <si>).
localcall =
Sets whether or not to allow subscribers to call other subscribers if the system’s
connection to the SIP server is not available.
mwi =
Turns the message waiting indicator on or off.
centrex
=
Enable or disable the centrex operation to specify their user. Centrex user operation
provide different call features and different way to invoke these call features.
1. Call transfer
2. Inquiry call
3. Broker call
4. Waitting call
5. Conference call
To Next Page
Loading...
