ZyXEL Communications MSC1000G - Page 950

Chapter 32 show Commands
Management Switch Card User’s Guide
950
This command displays the details of IMA group 2 on the line card installed in slot 2.
Syntax:
show ima link <slot-group> <link-id>
ras> show ima groupdetail 2-2
Admin Status : notInService
Failure state : insufficientLinksNe
Symmetry : symop
Near End Tx Clock Mode : itc
Max Differential Delay(ms) : 25
Least Delay Link : 0
Max Differential Delay observed : 0
Frame Sync Alpha : 2
Frame Sync Beta : 2
Frame Sync Gamma : 1
Running Seconds : 0
Unavailable Seconds : 199114
Tx Frame Len : 32
Rx Frame Len : 32
Last time on change Group setting : 2009-5-26 - 9:59:2
Near End State : insufficientLinks
Far End State : unknown
Min Num of Tx Links : 1 Min Num of Rx Links : 1
Near End Num of Failure : 2 Far End Num of Failure : 2
Test Link id : NULL Test Pattern : ff
Group Test Porcessing status : disabled
Seconds since current period started: 693
Valid 15 minutes Interval : 96 Invalid 15 minutes Interval : 0
Tx TRL link id : 2 Rx TRL link id : 0
Tx IMA id : 1 Rx IMA id : 1
Tx Available Cell Rate : 0 Rx Available Cell Rate : 0
Tx Num of Configured Link : 3 Rx Num of Configured Link : 3
Tx Num of Active Link : 0 Rx Num of Active Link : 0
Tx OAM Label : Ver 1.1
Rx OAM Label : Ver 1.1
port 1 port 2 port 3 port 4 port 5 port 6 port 7 port 8
---------------------------------------------------------------------------
CLKSRC 1 2 - - - 6 - -