ZyXEL Communications MSC1000G - Page 997

Chapter 33 switch Commands
Management Switch Card User’s Guide
997
33.5.3.12 switch cfm md delete
Syntax:
switch cfm md delete <md-name>
This command deletes a maintenance domain.
33.5.3.13 switch cfm md set
Syntax:
switch cfm md set <md-name> <level>
This command sets a maintenance domain and it’s level. The following example configures the
maintenance domain “md1” with a level of 2.
33.5.3.14 switch cfm mep delete
Syntax:
switch cfm delete <md-name> <ma-name> <mep-id>
This command deletes an endpoint in the maintenance association. The following shows an
example.
33.5.3.15 switch cfm mep set
Syntax:
switch cfm mep set <md-name> <ma-name> <mep-id> <giga-port>|<slot-port> <direction>
<priority> [cci <cci-enabled>] [alm <alarm-time>] [rst <reset-time>] [mac <mac>]
where
re
ras> switch cfm md set md1 2
ras> switch cfm md delete
<mep-id> =
The maintenance end point identifier.
<direction> =
Choose up|down.
Specify whether to send CCMs (Connectivity Check Messages) from the
specified end point (down) or from (up). Select up only when the link of the
specified end point is down.
<priority> =
Specifies the priority of the CCMs sent from this CFM end point.
<cci-enabled> =
Indicates whether to issue CCM or not (default is 0).
0: disabled
1: enabled
<alarm-time> =
This is the number of seconds (2.5~10) the system waits to send a local alarm
after three times of CFM_ERROR detected. The default is 2.5 seconds.