109
13-2-1. LINE DVE ON/OFF Button
Assign the LINE DVE ON/OFF function to a bus button.
In this example, the function is assigned to bus button 1 .
(1) Open the [PANEL > BUS ASSIGN > LEVEL1] menu.
(2) Turn F1 to select BUTTON 1. Turn F2 to select L-DVE under SIGNAL, then press F2.
PANEL > BUS ASSIGN > LEVEL1
Note that if in the [PANEL > BUS ASSIGN] menu, all M/E selection buttons are lit in the right side
of the menu screen, Button 1 in all bus rows including M/E1 PGM/PST, KEY/FLX, M/E2
PGM/PST and KEY/AUX have the LINE DVE ON/OFF function.
13-2-2. Enabling LINE DVE on a BUS
Assume that the LINE DVE ON/OFF function is assigned to Bus Button 1 :
To Enable LINE DVE on PGM or PST Bus
Press Button 1 to turn on the button light on the PGM (or PST) bus row.
To disable LINE DVE, press the button again to turn the bus off.
To do this in the menu, turn ON/OFF the LINE DVE parameter in [M/E FLEXaKEY > M/E1
(M/E2) > BKGD PGM (PST) MODIFY > DVE POS/SIZE] menu PAGE 1.
M/E FLEXaKEY > M/E2 > BKGD PGM > MODIFY > DVE POS/SIZE
To Enable LINE DVE for KEY1-4
(1) Press KEY1 or (KEY2-4) in BUS SELECT.
(2) Press Button 1 to turn on the button light on the KEY/AUX (or KEY/FLX) bus row.
To do this in the menu, turn ON/OFF the LINE DVE parameter in [M/E FLEXaKEY > M/E1
(M/E2) > KEY1 (KEY2-4) > MODIFY > DVE POS/SIZE] menu PAGE 1.
To Enable LINE DVE for FLEXaKEY1-4
(1) Press FLX1 or (FLX2-4) in BUS SELECT.
(2) Press Button 1 to turn on the button light on the KEY/FLX bus row.
To do this in the menu, turn ON/OFF the LINE DVE parameter in [M/E FLEXaKEY > FLX1
(FLX2-4) > MODIFY > DVE POS/SIZE] menu PAGE 1.
To Next Page
Loading...
