125
(4) Go to PAGE 2.
(5) Tap on REC READY to be on recording standby. (If the number of recording frames are
predetermined, turn F4 to set the number under OUT.)
(6) Tap on RECORD (red circle) to start recording.
(7) Tap on STOP (square) to stop recording. (If the number is set under OUT, the recording
will automatically stop.)
Clip data can be loaded to the switcher memory from SD cards. (See Sec. 22. “File
Operations.”)
Recording Mode (REC MODE)
The recording mode can be changed. To start recording with no standby (without tapping REC
READY), turn F2 to change REC MODE from STANDARD to DIRECT.
Loop Mode
The loop mode setting is shared by both recording and playback. Tapping the Loop button to
enable the loop mode. (The button becomes lit.)
When the switcher is recording in loop mode and the buffer is full, the recording will loop back
to the beginning, overwrite the previous recording and continue recording until the STOP
button is pressed.
17-2-2. Selecting Video Clips in V-RAM
Video clips can be loaded directly from V-RAM. The following procedure shows how to load a
clip stored in V-RAM to STILL 2.
(1) Open the [STILL/CLIP > STILL/CLIP] menu.
(3) Tap here, then turn
F2 to change to CLIP.
To Next Page
Loading...
