84
If a number button (lit red) cannot be overwritten:
Cancel the operation, change OVERWRITE from DISABLE to ENABLE in the [DIRECT
PATTERN] menu, then overwrite the pattern setting.
11-8-2. Loading a Direct Pattern
Let’s load DIRECT PATTERN10, which is saved in the previous chapter, to M/E2 KEY1.
(1) Press DIRECT PATT in the MEMORY block.
(2 Press PAGE, then 1 in the CONTROL block to select PAGE1.
(3) Press 0 in the keypad.
(4) Tap on M/E2 KEY1 button on the menu screen to specify the target.
(5) Press RECALL in the keypad. The M/E2 KEY1 pattern is changed to PATTERN 120 and
the transition type to WIPE.
If DIRECT in the [DIRECT PATTERN] menu is set to ON, direct patterns can be recalled by
pressing number buttons without pressing RECALL.
11-8-3. Clearing Direct Patterns
Clearing a Direct Pattern Individually
(1) Press DIRECT PATT in the MEMORY block.
(2) Press the number button to be deleted. (Press PAGE, then 1 first, if deleting 10-19.)
(3) Turn F1 to change DELETE to ON, then press F1.
Clearing a Direct Pattern Page
(1) Press DIRECT PATT in the MEMORY block to display the menu, then go to PAGE 2.
(2) Turn F2 to select a page (0 or 1), then press F2.
Clearing all Direct Patterns
(1) Press DIRECT PATT in the MEMORY block to display the menu.
(2) Turn F3 to turn ALL CLEAR to ON, then press F3.
Before clearing a direct pattern registration, set DIRECT to OFF. Otherwise, the selected
pattern is loaded immediately when pressing the number button.
To Next Page
Loading...
