161
(8) Tap YES on the pop-up screen to load the files to the switcher as a clip.
Sequential Image File Names
Up to 16 alphanumeric characters (Files whose name have 17 or more
characters cannot be loaded.)
Prepare sequential file names in the following name format.
Up to 16 alphanumeric characters (File names must be within 16
characters and excess characters are truncated on the right.)
Serial numbers starting from 0
File extension (bmp, jpg or tga)
If a clip file with the same name already exists in the V-RAM, the old file is overwritten by the
new one.
When loading a clip, tapping ABORT at the right side of the menu screen allows you to abort
clip loading.
22-4-5. Adding Audio to Sequential Image Files
Loading an audio with sequential image files allows you to add the audio data to the created
clip. The following procedure shows how to upload an audio file and multiplex it to a clip. WAV
files (Windows standard audio files) can be used as audio sources.
Load an audio file first, then a create clip. Otherwise the audio is not inserted to the clip.
Once the audio is multiplexed to the clip, the audio file is removed.
Loading an audio file
(1) Insert the SD card, in which sequential image files and an audio file are stored, into the
card slot. Follow Step (1) to (4) in the previous chapter to create a clip from the sequential
files.
(2) Open the [FILE > LOAD] menu.
(3) Turn F2 to select CLIP, and press F2.
(4) Turn F1 or tap on the folder to select SD/ (SD card to which the file is to be stored), then
the WAV file in it.
(5) Turn F3 to set the audio delay under AUDIO OFFSET. To add the audio from the
beginning of the clip, leave the value at zero.
(6) Turn F4 to select a destination and press F4.
(7) Tap YES on the pop-up screen to load the audio file.
To Next Page
Loading...
