FOR-A HVS-490 - CG WIPE Effects

127
17-2-4. CG WIPE
CG Wipes are video effects that allow you to play movie files according to background
transitions. CG Wipes can be created using a modified pattern. CG WIPE videos are
composed using an M/E key.
The procedure example below shows how to play a CG WIPE on the M/E1 background under
the conditions listed in the table. The CG clip should be stored in the switcher by capturing
video or uploading from an SD card.
Item
Setting example
Channel
STILL1
Pattern
No. 51
Key used for CG
M/E1KEY1
Play time
60 frames
BKGD transition type
WIPE
BKGD transition pattern
(preset or modified)
WIPE No. 51
 CG Settings
(1) Open the [M/E FLEXaKEY > M/E1 > BKGD PGM > MODIFY > CG WIPE] menu.
(2) Set ENABLE to ON to enable CG WIPE mode.
(3) Select STILL1 under CG.
(4) To select clips in V-RAM, tap SOURCE and select a clip in the pop-up dialog.
(5) Set DURATION (CG playback time) to 60 frames.
 KEY and Background Settings
(1) Go to PAGE 2. Select KEY1 KEYER SELECT.
(2) Set the delay time from the start of the CG WIPE to setting the key ON under KEYER
DELAY(f).
(3) Set TRANS END to KEY_OFF to clear KEY1 from the screen after CG playback is
finished.
(In CG WIPE operations, a key is cut into and cut out from the screen after the specified
time elapses.)
(4) Go to PAGE 3. Set the BKGD transition type to WIPE under TRAMS TYPE.
(Note that NOR/REV, the WIPE direction button, on the control panel must be OFF. In
other cases, CG wipes may be improperly performed.）
(5) Set the delay time from the start of the CG WIPE to the start of the background transition
under TRANS DELAY(f).
(6) Set the BKGD transition rate under TRANS RATE.
 Executing the CG WIPE
(1) Press the BKGD button in the TRANSITION block.
(2) On the control panel transition block, verify that the transition type is set to WIPE and
Pattern 51 is selected for the BKGD in the menu.
(3) Press AUTO to perform the CG WIPE effect.
 Fader Operation Setting
The FADER setting allows you to isolate CG WIPE and Fader operations.
(1) Open [M/E FLEXaKEY > M/E1 > BKGD PGM > MODIFY > CG WIPE] menu PAGE3.
(2) Turn F4 to select the fader operation from CG, MIX and WIPE.
FADER Setting
Description
CG
Moring fader performs CG Wipes in the same way as AUTO transitions.
MIX
Moving fader performs MIX transitions. CG Wipes are not performed.
WIPE
Moving fader performs WIPE transitions. CG Wipes are not performed.