05/2014
4-40
DC SC2020
8. Xerographic
Version 1.1
Disassembly/Assembly and Adjustment
Figure 2 j0bs40801
5. Install the Jig to the CRUM on the Bottom side of the Xero Unit.
(Figure 3)
(1) Insert the Boss (x2) in the CRUM Hole (x2).
Figure 3 j0bs40809
6. Move the Jig and CRUM towards the direction of the arrow by
pressing the CRUM Hole (x2) downwards in the Jig Boss (x2)
and remove the CRUM. (Figure 4)
NOTE: Do not touch the CRUM Substrate Surface in the
Replacement Kit.
Figure 4 j0bs40810
7. Install the CRUM in the Replacement Kit. (Figure 5)
NOTE: Push the CRUM in towards the direction of the arrow
until you hear the Lock sound.
NOTE: Do not touch the Substrate Surface (A).
Figure 5 j0bs40811
8. After installing, check to see if the Boss (x2) is sticking out from
the CRUM Hole (x2). (Figure 6)
Figure 6 j0bs40812
9. Remove the BCR Housing. (Figure 7)
(1) Remove the Tapping Screw (x2).
(2) Remove the BCR Housing.
Figure 7 j0bs40802
10. Remove the sleeve at the front. (Figure 8)
(1) Remove the Tapping Screw (x2).
(2) Remove the Sleeve.
To Next Page
Loading...
Need help?
General
