Fuji Xerox DocuCentre SC2020 Service Manual

05/2014
2-19
DC SC2020
Troubleshooting
CHAIN 5
Version 1.1
The DADF Feeder Cover Interlock Switch was opened during DADF operation.
Cause/Action
1. Check the DADF Feeder Cover for mismatch.
2. Check for malfunction of DADF Feeder Cover Interlock Switch (DADF IIT Input[005-212]). (PL 56.6)
3. If no problem is found, replace the DADF PWB. (PL 56.2)
005-500 DADF Download Flash Write Error
BSD-ON:CH3.2
Failed to write into the Flash ROM during DAFD Download.
Cause/Action
1. Turn the power OFF and ON.
2. If the problem persists, replace the following parts in sequence:
• DADF PWB (PL 56.2)
• ESS PWB (PL 18.2)
005-907 DADF Pre Regi. Sensor
BSD-ON:CH5.4,CH5.5
DADF Pre Regi. Sensor detected paper when Powering On, closing Feeder Cover Interlock, or closing
DADF Open Sensor.
Cause/Action
1. Check for any residue of paper on DADF Pre Regi. Sensor, returning malfunction of the Actuator,
Sensor uncleanness.
2. Check for malfunction of DADF Pre Regi. Sensor (DADF IIT Input[005-206]). (PL 56.14)
3. If no problem is found, replace the DADF PWB. (PL 56.2)
005-908 DADF Regi. Sensor Static Jam
BSD-ON:CH5.5
DADF Regi. Sensor detected paper when Powering On, closing Feeder Cover Interlock, or closing DADF
Open Sensor.
Cause/Action
1. Check for any residue of paper on DADF Regi. Sensor, returning malfunction of the Actuator, Sen-
sor uncleanness.
2. Check for malfunction of DADF Regi. Sensor (DADF IIT Input[005-206]). (PL 56.14)
3. If no problem is found, replace the DADF PWB. (PL 56.2)
005-913 DADF Invert Sensor Static Jam
BSD-ON:CH5.5
DADF Invert Sensor detected paper when Powering On, closing Feeder Cover Interlock, or closing
DADF Open Sensor.
Cause/Action
1. Check for any residue of paper on DADF Invert Sensor, returning malfunction of the Actuator, Sen-
sor uncleanness.
2. Check for malfunction of DADF Invert Sensor (DADF IIT Input[005-206]). (PL 56.10)
3. If no problem is found, replace the DADF PWB. (PL 56.2)
005-940 DADF No Original Fail
BSD-ON:CH5.1
It was detected that the document was pulled out during document feed.
Cause/Action
Reload the document.
005-942 Not-Supported Doc Size DADF
BSD-ON:CH5.4,CH5.2
Detected unsupported document size in DADF Scan.
Cause/Action
1. Check the size of the document that was fed by the User.
2. If the error is not cleared, check the following:
• Malfunction of DADF Pre Regi. Sensor (DADF IIT Input[005-206]). (PL 56.14)
• Malfunction of Document Tray Size Sensor 1/2 (DADF IIT Input[005-221/222]). (PL 56.11)
3. If no problem is found, replace the DADF PWB. (PL 56.2)
005-948 SS-Size Mismatch Jam on No Mix-size
BSD-ON:CH5.4,CH5.2
In No Mix mode, it was detected that a document with a shorter size in Slow Scan (SS) direction was
transported from the DADF. (Notify Fail when (NVM[710-600] value is "3", size mismatch was detected,
vertical scanning length was short.)

Fuji Xerox DocuCentre SC2020 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre SC2020
Category	All in One Printer
Language	English