05/2014
4-90
DC SC2020
56. DADF
Version 1.1
Disassembly/Assembly and Adjustment
Figure 4 j0lj45660
7. Remove the screws that secure the Sensor Bracket. (Figure 5)
(1) Disconnect the connector.
(2) Remove the Tapping Screw (x2).
Figure 5 j0lj45661
8. Remove the Sensor Bracket from underneath the DADF Take-
away Roll. (Figure 6)
(1) Lift up the Front side of the DADF Takeaway Roll.
(2) Remove the Sensor Bracket.
Figure 6 j0lj45662
9. Remove the DADF Pre Regi Sensor. (Figure 7)
(1) Release the hook to remove the DADF Pre Regi Sensor.
(2) Disconnect the connector.
Figure 7 j0lj45663
10. Remove the DADF Regi Sensor at the back of the Sensor
Bracket. (Figure 8)
(1) Release the hook to remove the DADF Regi Sensor.
(2) Disconnect the connector.
Figure 8 j0lj45664
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the Bearing of the DADF Takeaway Roll, align
the Cutout of the DADF Takeaway Clutch at the Rear side to
the Tab of the Bracket of the DADF Feed Motor. (Figure 9)
Figure 9 j0lj45665
3. When installing the Bracket and Ground Plate, install the
Ground Plate as shown in the figure. (Figure 10)
To Next Page
Loading...
Need help?
General
