05/2014
2-72
DC SC2020
CHAIN 50
Version 1.1
Troubleshooting
2. Line up the 4 corners of the paper that was taken out.
3. Face down the side you want to print and insert the paper until it touches the insertion port.
4. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-121 IOT Remain Zone 1T JAM
BSD-ON:-
Detected leftover paper near 1T.
Cause/Action
1. Pull out Paper Tray1.
2. Remove the jammed paper.
3. Slowly insert the Paper Tray all the way in.
4. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
050-122 IOT Remain Zone 2T JAM
BSD-ON:-
Detected leftover paper near 2T.
Cause/Action
1. Pull out Paper Tray2.
2. Remove the jammed paper.
3. Slowly insert the Paper Tray all the way in.
4. Proceed to JAM Error (07X-XXX) FIP when it is not recovered.
To Next Page
Loading...
Need help?
General
