Removal and replacement: Left door
●
Introduction
●
Step 1: Remove the left door
●
Step 2: Unpack the replacement assembly
●
Step 1: Install the left door
Introduction
This document provides the procedures to remove and replace the left door.
Before performing service
Turn the printer power o
◦
Disconnect the power cable.
WARNING! To avoid damage to the printer, turn the printer o, wait 30 seconds, and then remove the
power cable before attempting to service the printer.
Use the table below to identify the correct part number for your printer. To order the part, go to
www.hp.com/buy/parts.
Left door kit part number
G1W39-67926 Left door with instruction guide
Required tools
●
No special tools are needed to remove or install this assembly.
After performing service
Turn the printer power on
◦
Connect the power cable.
◦
Use the power switch to turn the power on.
Post service test
No post service test are available for this assembly.
Step 1: Remove the left door
1. Release the latch (callout 1), and then open the left door.
ENWW Removal and replacement procedures 77
To Next Page
Loading...